Unity of Command Forums

Hi

Am in the middle of creating a whole 'Ost Front' scenario from Leningrad to Novorossiysk and need some advice on how to get Wehrmacht reinforcements to appear at certain Hex's. I have created the reinforcement list so they appear on certain turns, but can't seem to work out how to get them deployed.

Any help would be great!!

1. When you hover the cursor over the map in the editor, a set of grid co-ordinates are shown at the bottom of the tool box. (lets just call them 103,13 as an example)
2. Select a unit in the forcepool now that you have the desired coordinates. The unit detail window pops up (the same one where you set the turn for the unit to appear/become available)
3. At the bottom of this window there is an slot next to the title "deploy". Fill in this with the coordinates like this

Thats all there is to it.[

PS. If you want more hexes as deployment zones for the same unit just (lets say 103,13 and 104,55). Then just enter
PPS. I recomend starting out with small scenarios first just to get the hang of the editor before making something major

Thanks Dan! That's going to be a great help.

Yeah I thought about going for something small to start off with but it all got a bit out of control and now I have the whole front line complete for both the Wehrmacht and Soviet forces with reserves.

Just a case of setting defend points and then I should be able to put it up for comments/ideas.

Thanks again!